hoover steamvac plus 5 rotating brushes manual

ホーム
ames wheelbarrow 4 wheel
mario sports games, ranked
hoover steamvac plus 5 rotating brushes manual

2022.07.31
why does my kitten chew on everything

hoover steamvac plus 5 rotating brushes manual

Do not remove plastic screen or foam from attachment. If lint or other debris becomes lodged in the nozzle, do not attempt to remove nozzle cover. (See Figure 9), Step on pedal (A) again to turn cleaner off. (See Figure 12), The cleaner may also be lifted by placing a hand under the upper clean solution tank handle as shown. Error: Either the email is already subscribed or you entered an invalid email. 1998-07-27T14:44:57 boots on carpet image by jimcox40 from Fotolia.com.

Rotate lid down onto tank. Fill Clean Water Solution Tank with HOOVER Detergent according to instructions on pages 8. Replace panel with converter (F). Slide converter halfway down opening until it is firmly in place. 0000026141 00000 n Wash hands after using. 1). Fill Clean Water Solution Tank with HOOVER detergent (available at additional cost if not included with your model) according to instruction on page 8. Always disconnect cord from electrical outlet before servicing the carpet cleaner.

Do not modify the plug provided with the appliance. Refer to Fig. 2.10 Unlatch back part of tank lid and remove lid. Make crisscrossing strokes to the original pattern; overlap each pass. Use only attachments recommended by Hoover; others may cause hazards. Keep children and pets away from carpets until they are completely dry. Attach tool to hose and turn the carpet cleaner ON. for a long time on very short carpet but trying to clean anything with (See Figure 29), Press all four latches (B) and pull brush block out. The Clean Water Solution Tank holds the cleaning solution that is to be dispersed onto the surface to be. 4.3Pull Dirty Water Tank front panel (E) up one inch then rotate forward so it is horizontal to floor. Sign up to receive special online promotions, cleaning tips and new product updates! It is best to alternate wet and dry strokes as described above. Please enter the complete model and Manufacturing Code in the spaces provided. Hoover F5915100. Move speed selector to Gentle Scrub for gentle cleaning or Power Scrub for normal cleaning. 2017-11-13T21:49:41-08:00 Unplug before connecting the powered hand tool (available on select models). 4.11 Gently press the tool onto the fabric. Unplug carpet cleaner from outlet when not in use. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, take it to a Authorized Hoover Warranty Service Dealer.

Step on handle release pedal and lower handle to operating position; turn carpet cleaner ON. Fit converter over tab near tool holder (I).

Only use cleaners designed for use in carpet cleaning machines. Hoover SteamVac Hoover FH50010 Manual. 4.12 For heavily soiled areas, it may be necessary to repeat the cleaning process. At that time the yellow float disk will rise to the top of the Dirty Water Tank lid. NOTE: Phillips screwdriver needed for assembly. Do not unplug by pulling on cord. Drain suction hose by turning carpet cleaner ON and holding end of hose up for several seconds. The clean solution tank holds the cleaning solution that is dispersed onto the surface to be cleaned. Pour one to two cups of clear water on a non-carpeted floor Do not pour water onto a wood floor. A. SpinScrub Hand Tool has rotating brushes for. WINDTUNNEL 3 HIGH PERFORMANCE PET UPRIGHT VACUUM, ONEPWR HEPA+ Cordless Upright Vacuum - Kit, ONEPWR Evolve Cordless Upright Vacuum - Two Battery Kit, WindTunnel 2 Whole House Rewind Upright Vacuum, WindTunnel T-Series Bagged Upright Vacuum, WindTunnel Air Steerable Pet Upright Vacuum, REACT Professional Pet Plus Upright Vacuum, WindTunnel T-Series Max Bagged Upright Vacuum, Complete Performance Advanced Upright Vacuum, ONEPWR Evolve PET Cordless Upright Vacuum - Kit, ONEPWR Dust Chaser Cordless Handheld Vacuum - Kit, SmartWash PET Complete Automatic Carpet Cleaner, ONEPWR Spotless GO Cordless Portable Carpet Spot Cleaner - Kit, Spotless Portable Carpet & Upholstery Cleaner, CleanSlate Pet Carpet & Upholstery Spot Cleaner. Close attention is necessary when used by or near children. Your email address will not be published. To avoid saturating carpet, do not use more than 4 wet strokes over any one area. Empty Dirty Water Tank and rinse thoroughly with clean water. 0000001236 00000 n

Make sure lid is secure on all sides before cleaning. Disconnect carpet cleaner from electrical outlet. USING THIS MACHINE ON HARD FLOORS WITHOUT PROPER ATTACHMENT MAY SCRATCH OR DAMAGE YOUR FLOOR. Use only on carpet moistened by cleaning process or small spills. The tank is located on the front of the machine, below the handle. Allow time for carpet or upholstery to dry completely between cleaning and rinsing. Pretreat spots and heavy traffic areas with a carpet precleaner. Make sure that square post (E) also aligns with square hole (F). Squeeze trigger and push carpet cleaner forward and back several times to expel any solution remaining in the carpet cleaners system. Replace empty solution tank and turn cleaner ON. 17 Actual model may vary from images shown.

Connect to a properly grounded outlet only. If furniture must be replaced before the carpet is dry, use plastic or aluminum foil pads under legs of furniture so metal slides or wood finishes will not stain the carpet. But deep cleaners like the Hoover go deep to loosen and remove stains, odors, and ground in dirt. Always end with dry strokes. (See Figure 15). For furniture too heavy to move, place aluminum foil or wax paper under legs. Connect to a properly grounded outlet only. Thanks Scott, just made a .pdf of your pictures for to file for future This will prevent wood finishes from staining carpet. Checking the Yellow Pages under Vacuum Cleaners or Household.

(Do not use carpet cleaner on wood floors.). Therefore, do not add lubricant to motor bearings. When the recovery tank is full, the automatic shut-off will engage (see page 3) and the tank must be emptied. Cap must be locked in place for proper performance and to prevent leaking. 0000009840 00000 n 2). Squeeze trigger and push cleaner forward and back several times to expel any solution remaining in the cleaners system. Some models have a nozzle clean-out tool for removing debris. 2.7 Pour detergent into tank. Repeat as necessary until debris is flushed out of nozzle. To avoid saturating carpet, do not use more than 4 wet strokes over one area. In the storage position, brush roll does not shut off. Which model do you have? In Canada, contact Hoover Canada, Toronto: 755 Progress Ave., Scarborough, ON M1H 2W7 OR Hoover Canada, Edmonton: 18129-111 Ave., Edmonton, AB T5W 2P2, Phone: 1-800-944-9200, Mon-Fri 8am-7pm EST. Directions on Using a Bissell PowerSteamer PowerBrush, Bissell Proheat Clearview Plus Instructions, Copyright 2022 Leaf Group Ltd. / Leaf Group Lifestyle, All Rights Reserved. G.To avoid wetting and possible damage to wood floors underneath area rugs/carpet, either move area rugs/carpet to a non-wood hard floor surface or place waterproof material (e.g. The cleaner will no longer pick up liquid and the motor sound will become noticeably higher in pitch. End with more dry strokes to aid in faster drying of carpet.

0000044796 00000 n

no help now that you found the problem. Raise handle to upright position and replace upper clean solution tank. Position the front of lid under tabs (P) on front of tank. IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. Do not send your vacuum to Hoover, Inc., Company in Glenwillow for service. Use only attachments recommended by Hoover, The use of an extension cord is not recommended. plastic) underneath them before cleaning. 0000000016 00000 n

Pull the nozzle very slowly over the spill initially with suction only. WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY: To avoid internal component damage, use only Hoover cleaning products intended for use with this Appliance. Occasionally, debris may become lodged inside of the hose at the converter end (L). Remove the cleaning solution tank. NOTE: Do not store cleaner with a full solution tank in place. Step on the release handle located on the right rear of the machine to unlock handle. Use your SteamVac carpet cleaner to pick up Spot and Stain Spray Cleaner and spot. Please do not return this product to the store. 4.18 Empty tanks, rinse with clear water and let air dry. To help prevent matting and resoiling, avoid contact with carpets until they are dry. Do not put any object into openings. Lift tank off of carpet cleaner and carry it to a sink or drain. 2.4 to remove Clean Water Solution Tank. 0000021835 00000 n Slide converter halfway down opening until it is firmly in place. Start cleaning the carpets from a corner, and then work toward a doorway; you will walk to walk on less damp carpet this way. 0000002005 00000 n Visit our website at hoover.com (U.S. Customers) or hoover.ca (Canadian customers). For an automated referral of authorized service outlet locations call, Upload manuals that we do not have and get. If the indicator does not spin (F) and the pattern is visible when the cleaner is turned on, the brushes are not rotating. READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE. Bolts (2)D. Nuts (3 one extra included)E. Carpet Detergent, The assembled spotter/carpet cleaner will look like the drawing. This gives the cleaning brushes time to scrub the carpet. This saturates the carpet with cleaning solution. 4.16Replace Dirty Water Tank front panel (O). (See Figure 24), Unlatch back part of tank lid and remove lid. 0000028547 00000 n Rinse the Clean Water Solution Tank cap and Dirty Water Tank lid and let air dry. 2.4 To remove tank, press down on handle and pull forward. 0000008254 00000 n 0000004079 00000 n Vacuuming is great for picking up dirt and debris at the surface of carpet.

Only two nuts are needed on this model. Replace empty Clean Water Solution Tank and turn carpet cleaner ON. Make sure all parts are located before disposing of packing materials. (See Figure 14), Brush speed selector is turned to Spill Pick Up (see previous section). Allow brushes and underside of cleaner to air dry thoroughly before storing cleaner on a carpeted or wood surface. Repeat as necessary until debris is flushed out of nozzle. Release trigger at end of stroke. 0000007338 00000 n When finished cleaning, follow After cleaning instructions below. (See Figure 10). If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, call Uline customer service. Lower handle and replace Dirty Water Tank. Position the front of lid under tabs (G) on front of tank.

Our has been trouble free for many years.

(See Figure 13). 0000005542 00000 n I found with that particular machine it works fine and (Continue using dry strokes until little water is visible passing through the recovery tank lid. 4.8 Pre-spray the carpeted stair by holding the tool (A or B in Fig. Remove clear cover over indicator and clean. When finished cleaning, follow After Cleaning instructions. Rotate tank cap counterclockwise and lift up to remove cap. 4.4Replace panel with converter (F). We are on our first one and we have a large house of carpeting. This will prevent wood finishes from staining carpet. Check clean solution tank also; it may need to be refilled. any kind of length to it seems to put to much stress on the pos plastic To reduce the risk of electric shock, unplug before cleaning or servicing. Do not press trigger. Pin up furniture skirts and draperies. Use extra dry strokes to aid in faster drying of the carpet. If an extension cord is absolutely necessary, use at least a 16 gauge 3-wire cord which has a 3-prong grounding type plug and a 3-pole receptacle that accepts the machine plug.